SUPERtrol Series 32 Bit Device Driver
for KEPware's KEPServer

 

Works in Conjunction with KEPware's DDE/OPC Server (KEPServer) to exchange data. KEPServer details can be found at: http://www.kepware.com Supports SUPERtrol I LE, SUPERtrol I, SUPERtrol II and LEVELtrol II.

This device driver has the ability to exchange data between DDE and OPC clients and Kessler-Ellis Products SUPERtrol devices. Block reads are optimized automatically. Block polling rates are defined by scanning blocks at the rate of the fastest tag scan rate in the block. Drive System Requirements are as follows: Windows 9x, Windows NT 3.51 or better, and a minimum of 16MB of RAM.

KEPServer Data Sheet (Size 125 Kilobytes)

RS-422/485 Interface Converter

Features

Description

 

User Selectable RS-422 or RS-485 RS-485 User Selectable 2 or 4-Wire Operation Intelligent Control of RS-485 Transmitter and Receiver Td and Rd LED DTE/DCE Compatible Date Rates up to 64k BPS Connects to Standard PC Compatible 25 Pin RS-232 Port

The CS-285 is a unique interface converter that can be configured by a user to convert either RS-422 or RS-485 to RS232 When operating in RS-485 mode, the CA-285 has an 'intelligent' mode which provides control of the RS-485 line.

CA-285 Data Sheet (Size 31 Kilobytes)

Port Powered Modem 2400 Baud Rate

Features

Description

 

Operates on All Telephone Lines RS232 Powered, No Batteries or AC Required 2400 BPS Operation Automatic Fallback Compatible with All Communications Software Automatic Answer Tone & Pulse Dialing Compact and Small for easy usage

The MPP-2400 Modem is ultra-compact and easy to install. It needs no batteries or AC power because it's designed to run on extremely low current from the interface to which it attaches. This modem can operate at speeds up to 2400 BPS, and can 'fall back' to slower speeds if your connected device requires it.

MPP-2400 Data Sheet (Size 86 Kilobytes)

MPP-2400N

Wall Mount Port Powered Modem

Features

Description

 

Operates on All Telephone Lines RS232 Powered from SUPERtrol 2400 BPS Operation Automatic Fallback Compatible with All Communications Software Automatic Answer Tone & Pulse Dialing Compact Wall Mount Enclosure FCC Approved

The compact and easy to install MPP-2400N is designed to run on DC power provided from the SUPERtrol interface to which is is attached. This unit also features automatic answer, and can operate over rotary or pushbutton lines since it works in tone or pulse dialing modes.

Industrial Two Way Pager
Wireless Data Transceiver

 

Wireless Communications Over ReFLEX Two Way Paging Network Compatible with KEP SUPERtrol II Flow Computers Request Information from SUPERtrol II on Demand, by exception or on a schedule basis Low Cost Solution for Moderate Message Lengths Up to 500 Bytes of Data per Transmission Confirmed Message Delivery Check Meter Readings over Internet or Pager

.The TWP is a two way wireless data transceiver intended for applications where Reflex Two Way Wireless Messaging will be used in remote metering applications using SUPERtrol II flow computers. The TWP is intended for fixed telemetry applications requiring moderate message length wireless communications.

TWP Data Sheet (Size 24 Kilobytes)